Rane AD 13 Manuel d'utilisateur télécharger pdf (Page 4)

II. FRONT PANEL DESCRIPTION

1. POWER SWITCH: Pressing the top half of this switch will cause the mechanism contained

within to connect power to the circuitry of the unit causing it to operate (ON). Pressing the

bottom half will snap the switch into the opposite operating mode (OFF).

2. BYPASS SWITCH: Pressing this momentary pushbutton toggles all of the outputs of the AD

13 between the active and bypass mode. Bypass is indicated on the LED display by an “OFF”

indication.

3. CHANNEL SELECT SWITCH: Pressing this momentary pushbutton advances the output

channel pointer by one increment which simultaneously displays the delay setting of the

selected channel on the LED display. THIS BUTTON ALSO CAUSESTHE DELAY SETTING OF

THE PREVIOUSLY SELECTED CHANNELTO BE STORED IN THE NON-VOLATILE MEMORY

OF THE AD 13.

4. OUTPUT CHANNEL POINTER: This LED pointer alerts the operator to the channel number

currently being displayed by the LED display.

5. LED DISPLAY: The primary purpose of this display is to inform the user as to the amount of

delay currently applied to any of the three outputs, these outputs being selected by the

channel select switch and pointed to by the LED channel pointer to its left. The display also

indicates overall bypass by an “OFF” indication and can be used to display the software

revision of the system while in the bypass mode by holding the channel select button down

and pressing the “DECREASE” switch.

6. DECREASE BUTTON: Pressing this button will decrease the amount of delay on the selected

channel. PRESSING THE CHANNEL SELECT BUTTON WHILE THE DECREASE BUTTON IS

HELD WILL TOGGLE BETWEEN THE 20 MICROSECOND DELAY STEPS AND 1 MILLI-

SECOND DELAY STEPS.

7. INCREASE BUTTON: Pressing this button will increase the amount of delay on the selected

channel. Pressing the channel select button while the increase button is held will toggle

between 20 microsecond delay steps and 1 millisecond delay steps.

8. CHANNEL 1 OUTPUT LEVEL CONTROL: This rotary control varies the output level of

channel 1 from “off” at its full counterclockwise position to unity at its center detent “12:00”

position to +20 dB at its full clockwise position.

1 2 3 4 5 6 7 8 9 ... 12 13

Pas de commentaire

Rane AD 13 Manuel d'utilisateur Page 4