Rane RPM 2 Manuel d'utilisateur télécharger pdf (Page 3)

Manual-1

RPM 2

PROGRAMMABLE MULTIPROCESSOR

HARDWARE MANUAL

WEAR PARTS: is product contains no wear parts.

QUICK START

is section is intended to help you make the physical con-

nections and software manipulations necessary to get up and

running with your sleek new RPM 2. If you don’t read the entire

Hardware Manual, at least read this section. It is also recom-

mended that you read the Quick Start section of the Drag Net

Software Manual. If the Drag Net software is not yet installed

on your computer, please install it now.

To be safe, leave the audio connections until last. Begin by

connecting the IEC power cord. Observe that the POWER LED

on the front panel illuminates. After a few seconds, the STATUS

LED should turn from red to yellow to green, and the PRESET

display should have a number in it (00, if it’s the rst time you’ve

powered the device). If the POWER comes on, but the STATUS

LED does not turn green, contact the factory.

Connect one end of the Ethernet crossover cable (supplied

with the unit) to the 10Base-T jack on the rear panel. Connect

the other end of the cable to an Ethernet port on your computer.

e LINK LED on the rear panel should be lit. If it is not,

verify that you are indeed using a crossover cable, not a stan-

dard Ethernet cable. Only use a standard Ethernet cable if you

are connecting the RPM 2 and a computer indirectly using an

Ethernet switch. Launch the Drag Net application and follow

the steps to create a new project and new RPM 2 device congu-

ration. Click the Congure Hardware IP shortcut and follow

the instructions to set the unit’s IP address to be compatible with

your computer’s Network settings. Tip: If you aren't sure what IP

to use, try the address 192.168.69.69 and subnet 255.255.255.0.

is nds the default factory address without manually setting it.

INPUT

OUTPUT

12 12

VIP POWER

ETHERNET STATUS

RPM 2

PROGRAMMABLE

MULTIPROCESSOR

PRESET

Now click the Poll button in the toolbar. A device name and

IP address should appear under the Live folder in the Project

window. If a device does not appear, consult Drag Net’s online

Help for instructions on conguring and verifying your comput-

er’s Network settings.

e audio path within the RPM 2 is displayed in Drag Net’s

Device Conguration window as a collection of blocks wired

together to form a Processing Map. ese maps are created

oine as Storage congurations, which are then transferred to

a Live unit. Drag blocks from the Palette onto the Process-

ing Map and wire them together to create the audio path. Save

this le frequently using the File > Save command. Transfer

the selected Storage conguration to a Live unit using the

Transfer Cong button in the Project window. A new, minty

green Device Conguration window opens once the transfer

is complete, indicating you are now online with a Live device.

Double-click a processing block to display and adjust its Prop-

erties (parameters) in real time on a Live device — there is no

need to go oine to make parameter changes.

Once you have a useful conguration in the unit, connect

balanced audio INPUTS and OUTPUTS to the Euroblocks on

the rear panel, then turn on the amplier. As a precautionary

measure, all outputs are muted during and after a conguration

transfer. Unmute each output individually, or use the handy

Mute Outputs button in the toolbar. Once all outputs are

unmuted, audio passes through the unit along the connections

you dened.

1 2 3 4 5 6 7 8 9 10

Commentaires sur ces manuels

Pas de commentaire

Rane RPM 2 Manuel d'utilisateur Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Rane RPM 2